Removing tiny infill

Hello,

I'm hoping someone has a quick answer for this problem. I've sliced a part, and I'm getting very small bits of infill, and I can't figure out how to remove them.. My minimum infill length is set to 3.00mm, yet these are still showing up. Not sure where else in the settings I would remove these. They slow the print time significantly. And, because I'm running a bowden set up, there's the retraction and wipe for every single one of these, it makes the whole print process much more cumbersome...

Please help.

I didn't find the right solution from the Internet.

References:-
https://forum.simplify3d.com/viewtopic.php?f=9&t=9744
Medical marketing examples

Thanks